[Feb-2024] Latest 300-730 Exam Dumps for Pass Guaranteed
Reliable CCNP Security 300-730 Dumps PDF Feb 27, 2024 Recently Updated Questions
NEW QUESTION # 23
Refer to the exhibit.
Which type of VPN is being configured, based on the partial configuration snippet?
- A. FlexVPN backup gateway
- B. FlexVPN load balancer
- C. GET VPN with dual group member
- D. GET VPN with COOP key server
Answer: D
NEW QUESTION # 24
Refer to the exhibit.
Client 1 cannot communicate with client 2. Both clients are using Cisco AnyConnect and have established a successful SSL VPN connection to the hub ASA. Which command on the ASA is missing?
- A. dns-server value 10.1.1.3
- B. same-security-traffic permit inter-interface
- C. dns-server value 10.1.1.2
- D. same-security-traffic permit intra-interface
Answer: D
NEW QUESTION # 25
An engineer is requesting an SSL certificate for a VPN load-balancing cluster in which two Cisco ASAs provide clientless SSLVPN access. The FQDN that users will enter to access the clientless VPN is asa.example.com, and users will be redirected to either asa1.example.com or asa2.example.com. The cluster FQDN and individual Cisco ASAs FQDNs resolve to IP addresses 192.168.0.1, 192.168.0.2, and 192.168.0.3 respectively. The issued certificate must be able to be used to validate the identity of either ASA in the cluster without returning any certificate validation errors. Which fields must be included in the certificate to meet these requirements?
- A. CN=*.example.com, SAN=asa.example.com
- B. CN=192.168.0.1, SAN=192.168.0.1, 192.168.0.2, 192.168.0.3
- C. CN=192.168.0.1, SAN=asa1.example.com, asa2.example.com
- D. CN=asa.example.com, SAN=asa.example.com, asa1.example.com, asa2.example.com
Answer: D
Explanation:
https://integratingit.wordpress.com/2020/03/14/asa-vpn-load-balancing/
NEW QUESTION # 26
While troubleshooting, an engineer finds that the show crypto isakmp sa command indicates that the last state of the tunnel is MM_KEY_EXCH. What is the next step that should be taken to resolve this issue?
- A. Confirm that the pre-shared keys match on both devices.
- B. Verify that the ISAKMP proposals match.
- C. Correct the peer's IP address on the crypto map.
- D. Ensure that UDP 500 is not being blocked between the devices.
Answer: A
Explanation:
https://www.networkworld.com/article/2288666/chapter-4--common-ipsec-vpn-issues.html
NEW QUESTION # 27
Which technology is used to send multicast traffic over a site-to-site VPN?
- A. IPsec tunnel on FTD
- B. GRE over IPsec on IOS router
- C. GRE tunnel on ASA
- D. GRE over IPsec on FTD
Answer: B
Explanation:
https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/216276-configure-route-based-site-to-site-vpn-t.html#anc6
NEW QUESTION # 28
Refer to the exhibit.
Which two commands under the tunnel-group webvpn-attributes result in a Cisco AnyConnect user receiving the AnyConnect prompt in the exhibit? (Choose two.)
- A. group-policy General internal
- B. authentication certificate
- C. group-alias General enable
- D. authentication aaa
- E. group-url https://172.16.31.10/General enable
Answer: A,C
NEW QUESTION # 29
Refer to the exhibit.
The customer can establish a Cisco AnyConnect connection without using an XML profile. When the host "ikev2" is selected in the AnyConnect drop down, the connection fails. What is the cause of this issue?
- A. Primary protocol should be SSL.
- B. The HostName is incorrect.
- C. The IP address is incorrect.
- D. UserGroup must match connection profile.
Answer: D
NEW QUESTION # 30
Refer to the exhibit.
An SSL client is connecting to an ASA headend. The session fails with the message "Connection attempt has timed out. Please verify Internet connectivity." Based on how the packet is processed, which phase is causing the failure?
- A. phase 9: rpf-check
- B. phase 5: NAT
- C. phase 3: UN-NAT
- D. phase 4: ACCESS-LIST
Answer: C
NEW QUESTION # 31
On a FlexVPN hub-and-spoke topology where spoke-to-spoke tunnels are not allowed, which command is needed for the hub to be able to terminate FlexVPN tunnels?
- A. interface virtual-template
- B. ip nhrp redirect
- C. interface virtual-access
- D. interface tunnel
Answer: A
Explanation:
On a FlexVPN hub-and-spoke topology where spoke-to-spoke tunnels are not allowed, the command that is needed for the hub to be able to terminate FlexVPN tunnels is interface virtual-template. The interface virtual-template command is used to configure a virtual template interface which provides a secure tunnel for FlexVPN connections. The other commands listed - interface virtual-access, ip nhrp redirect, and interface tunnel - are not related to FlexVPN and are not used to terminate FlexVPN tunnels.
NEW QUESTION # 32
A company is setting up a dynamic crypto map on the Cisco ASA at the headquarters to accept connections from the branch offices. There will be no IP subnet overlap between the branch offices, but the engineer does not know which encryption domains will be requested by the branch offices. Additionally, the company security policy states that routing protocol traffic should not leave the HQ network. Which solution should be used to route traffic back to the branches from the Cisco ASA with minimal administrative effort?
- A. Configure a default route with the tunneled keyword on all branch routers.
- B. Configure snapshot routing with EIGRP to send out of band routing updates.
- C. Configure Reverse Route Injection on the dynamic crypto map.
- D. Configure static routes for remote subnets.
Answer: C
NEW QUESTION # 33
An engineer would like Cisco AnyConnect users to be able to reach servers within the 10.10.0.0/16 subnet while all other traffic is sent out to the Internet. Which IPsec configuration accomplishes this task?
- A. Option C
- B. Option B
- C. Option A
- D. Option D
Answer: B
Explanation:
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_conn_ike2vpn/configuration/xe-3s/sec-flex-vpn-xe-3s-book/sec-cfg-flex-serv.html
NEW QUESTION # 34
Which command identifies a Cisco AnyConnect profile that was uploaded to the flash of an IOS router?
- A. webvpn import profile SSL_profile flash:simos-profile.xml
- B. crypto vpn anyconnect profile SSL_profile flash:simos-profile.xml
- C. anyconnect profile SSL_profile flash:simos-profile.xml
- D. svc import profile SSL_profile flash:simos-profile.xml
Answer: B
NEW QUESTION # 35
Which redundancy protocol must be implemented for IPsec stateless failover to work?
- A. HSRP
- B. VRRP
- C. GLBP
- D. SSO
Answer: A
Explanation:
Reference:
https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/17826- ipsec-feat.html
NEW QUESTION # 36
Cisco AnyConnect Secure Mobility Client has been configured to use IKEv2 for one group of users and SSL for another group. When the administrator configures a new AnyConnect release on the Cisco ASA, the IKEv2 users cannot download it automatically when they connect. What might be the problem?
- A. Client software updates are not supported with IKEv2.
- B. Client services are not enabled.
- C. The new client image does not use the same major release as the current one.
- D. The XML profile is not configured correctly for the affected users.
Answer: B
NEW QUESTION # 37
A user is experiencing delays on audio calls over a Cisco AnyConnect VPN. Which implementation step resolves this issue?
- A. Enable DTLS.
- B. Change to 3DES Encryption.
- C. Shorten the encryption key lifetime.
- D. Install the Cisco AnyConnect 2.3 client for the user to download.
Answer: A
NEW QUESTION # 38
Refer to the exhibit.
Which two conclusions should be drawn from the DMVPN phase 2 configuration? (Choose two.)
- A. EIGRP is used as the dynamic routing protocol.
- B. EIGRP neighbor adjacency will fail.
- C. EIGRP route redistribution is not allowed.
- D. Spoke-to-spoke communication is allowed.
- E. Next-hop-self is required.
Answer: A,D
NEW QUESTION # 39
Which feature of GETVPN is a limitation of DMVPN and FlexVPN?
- A. design for use over public or private WAN
- B. enabled use of ESP or AH
- C. no requirement for an overlay routing protocol
- D. sequence numbers that enable scalable replay checking
Answer: C
Explanation:
Section: Secure Communications Architectures
NEW QUESTION # 40
Refer to the exhibit.
Which component must be configured on routers for a GETVPN deployment work properly?
- A. PE3: Key Server - all CEs: Group Members
- B. R1: Key Server - Customer 1 CEs: Group Members
- C. PE3: Key Server - Customer 2 CEs: Group Members
- D. Customer 1 CE1: Key Server - R1 and Customer 1 CE2: Group Members
Answer: C
NEW QUESTION # 41
......
Cisco 300-730 exam is a certification exam designed to test the knowledge and skills of IT professionals in implementing secure solutions with virtual private networks (VPNs). 300-730 exam is one of the requirements to obtain the Cisco Certified Specialist - Security Identity Management Implementation certification. Implementing Secure Solutions with Virtual Private Networks certification is intended for professionals who want to specialize in the implementation of secure identity management solutions.
Cisco 300-730 exam is an advanced level certification that tests the candidate's knowledge of implementing secure solutions using virtual private networks. It is designed for network security engineers who are responsible for implementing secure VPN solutions for their organizations. Implementing Secure Solutions with Virtual Private Networks certification validates the candidate's skills and expertise in implementing and maintaining secure VPN solutions using different technologies and protocols.
Latest 2024 Realistic Verified 300-730 Dumps: https://torrentpdf.exam4tests.com/300-730-pdf-braindumps.html